Cheap Side Table Extension for MK-370EXP & 770 EXP tile saws. Review
Showing posts with label Extension. Show all posts
Showing posts with label Extension. Show all posts
3/16/10
TABLE EXTENSION RYOBI - RIDGID 089100210002
Cheap TABLE EXTENSION RYOBI - RIDGID 089100210002 Review
3/15/10
Laguna Tools Angle Extension Table for TS, TSS, & L2700
Cheap Laguna Tools Angle Extension Table for TS, TSS, & L2700 Review
3/12/10
Bosch TS1003 Table Saw Left Side Support Extension
Cheap Bosch TS1003 Table Saw Left Side Support Extension Review
Watch Video Here: http://www.amazon.com/review/R366E58EMMI59N There seem to be plenty of conflicting reviews on both the left side extension and the outfeed extension, and I've made this video to clear them up. Issues cleared up:
- The front bar for the left side extension is short enough to not hit the red lever for the right side extension.
- Both left side extension and outfeed extension come with a stop knob for securing the extensions either open or closed.
- Both extensions sag just a little, which I fixed by placing a washer (approx 0.043 in thick) between the brace and the tablesaw for the _back_ bolt on each bracket. This modification brought it very close to level, for just over in washers at my local big box hardware store.
I do say a few odd words here and there in the video (quarters when I meant washers, etc.) But I'm sure you can figure it out.
Overall review: These were what I expected, fit my 4100 series Bosch worksite table saw, and were easy to install following the included instructions.
3/6/10
DEWALT DW7462 Heavy-Duty Table Saw Cast-Iron Extension Wing
Cheap DEWALT DW7462 Heavy-Duty Table Saw Cast-Iron Extension Wing Review
I have had the DeWalt 746 for a few months now, and I have been slowly adding accessories as I needed/could afford them. With a router table wing mounted on the left side, I chose to go ahead and put this wing on the right.
The wing shipped in good time and arrived undamaged. I was able to unpack and install it properly in about 25 minutes. Leveling it was not hard - in fact I was able to mount it by myself. The surface is blemish free and flat (within acceptable tolerances). No cast iron is "perfectly" flat", and neither the DeWalt saw table or this wing are either, but they are within a few thousandths...
Basically what I am saying is that this wing is worth buying. If you are like me and you are buying it after the fact, it will be hard to justufy spending the money when you could just get by with the steel wing, but then who wants to "just get by"?
Buy it, you won't regret it ever.
3/5/10
Subscribe to:
Posts (Atom)